600568 Rel-0006
4 of 7
Prior to programming the CoverLink System complete the following steps at the Autoshut Off Board and
Coverlink Receiver:
Uncover and cover the pool completely by pushing the buttons on the CoverLink Receiver located in the
Autoshut Off Box as shown on page 1 in illustration CoverLink Receiver.
If the operation of the cover is sluggish or stopping adjust the "amp limiter located on the Autoshut Off Board
as described in document #600356 WIRING AUTOSHUTOFF AMP LIMIT BRD-ACCB-AMP LMT LED FUNC.
5.
LINK CONTROL PAD AND RECEIVER
This process may require more than one person if Control Pad is not within reach of Receiver. Buttons must
be pressed within 20 seconds of each other or Programming access will time-out.
Step 1
Enter Setup Mode:
1.
Control Pad:
Press
and
Hold U
(Uncover) and
3
until both LEDs turn "ON" (5 sec.).
2.
Enter 396207
(6 digit Security code)
a.
Control Pad: Red LED "OFF" - Green LED "ON".
Step 2
Link Radio Signal:
3.
Receiver:
Press
and
Hold
the
Setup
button.
a. Receiver: Red LED "ON".
4.
While
Holding
the
Setup
button on Receiver
Press and Release 1
on the Control Pad.
a.
Control Pad: Green LED will flash once then "ON" indicating link is established.
b. Control Pad: Red LED "ON" then Link is not established repeat 4.
(If your wish to abort Setup - press 4)
Step 3
Set Channel Number:
5.
Press 2
to enter Channel mode.
a. No LEDs "ON".
6.
Enter 2 digit Channel Number
(00 - 31). (Example: 08)
a.
Control Pad: Green LED "ON" if Channel is accepted.
b. Control Pad: Red LED "ON" if Channel is not accepted, repeat 5 and 6.
Step 4
Set Network ID Number:
7.
Press 3
to enter Network mode.
a. No LED's "ON".
8.
Enter 2 digit Network ID Number
(00 - 99) (Example: 09).
a. Control Pad: Green LED "ON" if Network ID is accepted.
b. Control Pad: Red LED "ON" if Channel is not accepted, repeat 7 and 8.
Step 5
End Setup:
9.
Press 0
on Control Pad.
a.
Control Pad:
Green LED will flash once if accepted.
Link is complete and system is ready for normal operation.
(See NORMAL OPERATION and PIN SETUP)
b. Control Pad: Red LED "ON" if Link is not accepted, wait 20 seconds and repeat Link
procedure.
©Cover-Pools Inc.
4 of 7
600568 Rel-0006
E
le
c
tr
ic
a
l D
e
ta
ils
7
:2
2
