600568 Rel-0006
3.
DELETE PIN
3.1. Delete PIN (except master):
To erase one PIN at a time from the Receiver follow this process. Buttons must be pressed within 20
seconds of each other or Programming access will time-out.
3.1.1.
Enter '1583'
(or current Master PIN)
a.
Red LED will flash as each button is pressed.
b.
Green LED will flash if PIN is accepted.
3.1.2.
Press 1
to enter programming mode.
a. Red and Green LED "ON".
3.1.3.
Press 2
to enter PIN delete mode.
a.
Green LED will flash.
3.1.4.
Press
(
2, 3, or 4
) to delete PIN from that memory location.
a.
Green LED will flash.
(If you wish to abort PIN Delete - press 0)
3.1.5.
Press
(
2, 3, or 4
)
again
for confirmation.
a. Green LED "ON" after brief delay indicating success.
b. System is ready after 20 sec. delay and Green LED is "OFF".
3.2. Delete all PINs (except master):
To erase all PINs except master from the Receiver follow this process. Buttons must be pressed
within 20 seconds of each other or Programming access will time-out.
3.2.1.
Enter
'
1583'
(or current Master PIN)
a.
Red LED will flash as each button is pressed.
b.
Green LED will flash if PIN is accepted.
3.2.2.
Press 1
to enter programming mode.
a. Red and Green LED "ON".
3.2.3.
Press 3
to enter all PIN delete mode.
a.
Red and Green LED will flash.
(If you wish to abort PIN Delete - press 0)
3.2.4.
Enter master PIN
to verify delete.
a. Green LED "ON" after brief delay indicating success.
b. System is ready after 20 sec. delay and Green LED is "OFF".
4.
RECEIVER RESET
Reset Receiver to factory default:
(See Illustration on page 1 for Setup button location)
This process may require more than one person if Main Power (Breaker) is not within reach of Receiver.
To erase the Receiver memory including all linked Control Pads follow this process.
•
All Control Pads must be re-linked to Receiver and PINs re-established.
(See LINK CONTROL PAD AND RECEIVER to reestablish link).
Verify Board Revision before proceding (located on Receiver Label)
For Revisions up to 5
4.1.
Turn
power "OFF"
for
10 sec
.
4.2.
Hold Setup
button
down
while turning
power "ON"
.
The Green LED on the Receiver will flash briefly indicating the erasure is complete.
For Revisions 5+ or higher
4.3.
Push and release Setup button. Wait for red LED to go out.
•
The Receiver is returned to factory default setting.
3 of 7
©Cover-Pools Inc.
3 of 7
600568 Rel-0006
E
le
c
tr
ic
a
l D
e
ta
ils
7
:2
1
