#11 BOLT M6*25
25
PAGE 3 OF 6
NOTE:
The arrow marks on the center connector (#3)
should coincide with Figure 2 to ensure proper
assembly.
Step 3:
Turn the table to its upright position. Open the
cartons of the tiles, then put the tiles (#4 and #5)
onto the table top. See Figure 3.
FIGURE 2
FIGURE 3
Step 2:
Fasten the center connector (#3) to the middle of
the legs (#2) by using bolts (#11) and washers
(#12). Make sure that all of the bolts have been
tightened completely and cover them with bolt
caps (#17). See Figure 2.
NOTE:
1. If the rubber bumpers attached on the table top
are missing, you can place the rubber bumpers
in hardware kit to the table top. See Illustration A.
2. Do not throw the residual tiles away, retain them
for future reference.
A
2
2
2
11
12
17
2
3
4
5
FIGURE 1
ATTENTION:
Make sure that each bolt needed for all steps
matches the corresponding figure to ensure proper
assembly.
NOTE:
There are some parts in other carton.
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Fasten the legs (#2) to the table top (1) rim by using
bolts (#10), washers (#12) and plastic nuts (#15).
Do not tighten the bolts yet. See Figure 1.
#10 BOLT M6*35
35
17
17
1
2
2
2
2
10
10
12
12
12
12
15
15
STOP
DON’T RETURN TO STORE!
