Aaaembly(Note: For all nut and bolt
fastening, always use a washer (#18 and #19)
between the tube and bolt or the tube and
nut).
Step 1:
Attach the front and rear upright supports
(#2 and #3) at the top by using bolts (#13),
washers (#18) and plastic nuts (#21).
Repeat the procedure for the other side.
Do not tighten plastic nuts and bolts yet.
See Fig. A - Step 1.
Step 3:
Fasten the lateral cross braces (#4) to the
upright supports (#2 and #3) by using bolts
(#14), washers (#19) and plastic nuts (#20).
See Fig. A - Step 3.
Step 4:
Fasten the rear cross brace (#5) to the rear
upright supports (#2) by using bolts (#14),
washers (#19) and plastic nuts (#20).
Insert the leg caps (#25) to all base feet.
Tighten the plastic nuts and bolts now.
See Fig. A - Step 4 and Step 5.
Step 5:
Fasten one seat and back support brace (#6)
to the seat of two seat assemblies (#7) by
using bolts (#16) and washers (#19).
See Fig. B.
Note:
Make sure the two arcs of the seat and back
support brace (#6) should be facing outside.
PAGE 3 OF 6
Fig. B
Fig. A
Step 5
Step 4
Step 3
Step 1
Do not tighten bolts
after Step 1. Fasten
all bolts after Fig A.
Step 2
Step 2:
Attach the top cross beam w/adjustable
teeth (#1) to both ends of the upright
supports (#2 and #3). See Fig. A - Step 2.
STOP
DON’T RETURN TO STORE!
