PAGE 3 OF 5
Fig. A
Fig. B
Step 1:
Fasten the front and rear upright support (#2
and #3) at the top, by using bolts (#9), washers
(#14), and plastic nuts (#16). Do the same
procedure for both sides. Do not fully tighten
the plastic nuts and bolts yet.
See Fig. A – Step 1.
Step 5:
Open the seat assembly (#6) and fasten a
swing arm tube (#8) and a swing arm (#7) to
the seat back by using bolt (#11), and washers
(#15). Do the same procedure for both sides.
Fasten another swing arm tube (#8) to the
swing arm (#7) at the front bend by using bolt
(#11), washers (#15), and plastic nut (#17).
Do the same procedure for both sides. Fasten
the other end of the swing arm (#7) to the front
of the seat assembly (#6) by using bolt (#12),
and washers (#14). Do the same procedure for
both sides. See Fig. B.
Step 1
Step 2
Step 3
Step 4
Step 5
8
8
11
15
21
21
21
21
10
5
10
3
2
3
3
4
3
1
2
2
3
3
1
14
14
16
2
3
14
2
4
15
8
8
Do not tighten bolts
after Step 1. Fasten
all bolts after Fig A.
9
16
14
9
15
17
15
17
12
14
7
7
7
6
6
Note:
When fastening with bolts and nuts, always use
a washer (#14 and #15) between the tube and
the bolt and the tube and the nut.
Step 2:
At both ends, insert the assembled upright
supports (#2 and #3) into the top cross beam
w/adjustable teeth (#1). Tighten all plastic nuts
and bolts now. See Fig. A – Step 2.
Step 3:
Fasten the lateral cross braces (#4) to the
upright supports (#2 and #3) by using bolts
(#10), washers (#15), and plastic nuts (#17).
Do the same procedure for both sides.
See Fig. A – Step 3.
Step 4:
Fasten the rear cross brace (#5) to the rear
upright supports (#3) by using bolts (#10),
washers (#15), and plastic nuts (#17). Insert
the leg caps (#21) into all of the base feet.
Tighten all of the plastic nuts and bolts.
See Fig. A – Step 4 and Step 5.
11
15
17
15
8
8
15
E-2
