Countryline 312419699, Owner'S Manual

Page: 2 / 16

Safety 2
Important Safety
Instructions
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should be
followed during installation, operation, and
maintenance of the product. This is the
safety alert symbol. When you see this symbol
on your pump or in this manual, look for one of
the following signal words and be alert to the
potential for personal injury!
indicates a hazard which, if not
avoided, will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions
in this manual and on pump .
Keep safety labels in good condition. Replace
missing or damaged safety labels.
California Proposition 65 Warning
This product and related
accessories contain chemicals known to the
State of California to cause cancer, birth defects
or other reproductive harm.
1. Read this manual carefully. Failure to follow
these Instructions could cause serious bodily
injury and/or property damage.
2. Consult installer or licensed plumber for
correct relief valve. Install system according to
local codes.
3. Always test water from well for purity before
using. Check local health department for
testing procedure.
4. Before installing or servicing tank, BE SURE
pump electric power source is disconnected.
Release all water pressure before working on
tank or system. Release air pressure before
removing cover flange.
5. Install relief valve in pump supply line to tank,
as close to tank as possible.
6. BE SURE pump electrical circuit is
properly grounded.
7. Remove bleeder orifices, air volume controls
or other air charging devices in existing system.
8. DO NOT USE tank as a surge suppressor.
Risk of explosion . To prevent
possible serious or fatal injury and/or damage to
equipment, system pressure must be less than
100 pounds per square inch (PSI) (689kPa) under
any circumstances. Failure to follow instruction
can result in tank blowup. If system discharge
pressure can exceed 100 PSI (689kPa), install a
relief valve capable of passing the full pump
volume at 100 PSI (689kPa).
Risk of freezing . Do not allow
pump, tank, or piping system to freeze. Freezing
can severely damage equipment and may lead
to tank explosion and serious injury. Allowing
tank to freeze voids tank warranty.