ENG
LISH
7
2. ASSEMBLING THE CART
Parts Required:
1 x Cart Leg Assembly - Left
(#4)
1 x Cart Leg Assembly - Right
(#5)
8 x Washer
(#B)
8 x Nut
(#C)
8 x Long Screw
(#D)
Installation:
• First, loosen the four preassembled wingnuts on each of the legs,
leaving a gap of 8-9mm (0.3-0.35 in).
• Install the Left Cart Leg Assembly into the left Cart Leg Brackets of the
Firebox using two long screws, two washers, two nuts.
• Repeat the same installation for the Right Cart Leg Assembly into the
right Cart Leg Brackets of the Firebox.
IMPORTANT: Once all the parts of the cart are assembled, go back
and fully tighten all hardware. Be careful not to over-tighten, as that
could damage or strip threads.
3. ATTACHING THE FIREBOX HANDLES
Parts Required:
2 x Firebox Handle
(#2)
4 x Washer
(#E)
4 x Screw
(#G)
Installation:
• With the unit remaining upside-down, attach the Firebox Handle to
the side panel of the Firebox using two screws and washers.
• Repeat the same installation of the other Firebox Handle on the
opposing side of the Firebox.
• Once the cart is secure, carefully lift the unit into an upright position.
Attach the leg brackets (2) and leg right front bracket (3) to the firebox (1) using
screws (A).
Eight of the nuts (closest to the hot plate) are pre installed for your convenience.
Attach the legs (6) and (7) to the leg bracket installed in STEP 1 using screws (D),
washers (B) and nuts(C) as shown below.
2
Attach the leg brackets (2) and leg right front bracket (3) to the firebox (1) using
screws (A).
Eight of the nuts (closest to the hot plate) are pre installed for your convenience.
Attach the legs (6) and (7) to the leg bracket installed in STEP 1 using screws (D),
washers (B) and nuts(C) as shown below.
D
D
D
D
4
5
C
C
B
B
B
B
Attach the handles (4) from underneath using screws (G), washers (E) and nuts (F) to
secure the handles.
Further install the regulator hose hook (5) with a screw (G) and a nut (F).
3
2
E
E
G
G
C C
