Country Hearth 2200iA, Owner'S Operation And Instruction Manual

Page: 6 / 24

6 Ussc
ASSEMBLY INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED FOR INSTALLATION
TOOLS
• Pencil
• 6 foot Folding Ruler or Measuring Tape
• Tin Snips
• Drill: Hand or Electric
• 1/8” dia. Drill Bit (for sheet metal screws)
• Screwdrivers (Blade and Phillips type)
• 14mm Nut Driver or Ratchet with 14mm Socket
CAUTION: THIS APPLIANCE IS HEAVY. MAKE
SURE THAT YOU HAVE ADEQUATE HELP AND USE
PROPER LIFTING TECHNIQUES WHENEVER MOV-
ING THIS APPLIANCE.
1. Clean the fi replace opening properly disposing of
any ashes in a closed metal container. See Safety
Instructions.
2. Install a 6 ˝ (152mm) minimum diameter, continuous
stainless steel chimney liner into the existing chim-
ney. The liner must extend to the top of the existing
chimney. Use only listed chimney liners that meet
UL1777 standards. Follow liner manufacturer instal-
lation instructions.
3. Remove or lock the fi replace damper in the open
position. Note: Masonry or damper plate may be re-
moved to accommodate the chimney liner provided
this does not weaken any structural components of
the existing
fi replace or chimney nor reduces protec-
tion of combustible materials required by national
building codes. Consult with your local building or
fi re
authority before doing this.
4. Uncrate the appliance, remove all packing materials,
and any items stored in the fi rebox.
5. WARNING: Any fi replace which has had parts re-
moved or modi fi ed to accommodate the installation
of this appliance MUST have a warning plate perma-
nently installed in a visible location stating that the
fi replace is un fi t for use with solid fuel. Permanently
attach the warning plate to a visible location in the
fi replace.
6. Position the appliance into the fi replace opening until
the top lip of the air jacket is fl ush with the fi replace
facing.
8. Level the appliance with the adjusting screws at the
rear of the appliance.
9. Connect the chimney liner to the appliance using a
stainless steel adapter and securing with a minimum
of three (3) sheet metal screws. The liner MUST be
attached with the male (or crimped) end of the adapt-
er inside the
fl ue collar of the appliance to allow con-
densation and/or creosote to drain back into the fi re-
box.
10. Assemble the Surround. Lay pieces face down on
carpet or other soft surface to protect fi nish during
assembly. The Surround consists of two side panels,
a top panel, and a decorative trim frame.
MATERIALS
(NOTE: The following items are NOT included with your stove.)
Flooring Protection: as speci
fi ed herein.
Chimney Liner: Continuous stainless steel chimney liner
(as required)
Stainless Steel Adapter (connects the liner to the fl ue collar)
1/2” Sheet Metal Screws
Furnace Cement (manufacturer recommends Rutland
Code 78 or equivalent)