Country Clipper Wrangler 140, Operator'S Manual

Page: 11 / 28

10
MAINTENANCE
CAUTION
BEFORE PERFORMING ANY MAINTENANCE, TURN OFF ENGINE
REMOVE KEY AND DISCONNECT SPARK PLUGS. USE EXTREME CARE WHEN WORKING ON
MACHINERY. DO NOT WEAR WATCHES OR JEWELRY. DO NOT WEAR LOOSE FITTING
CLOTHES, AND OBSERVE ALL COMMON SAFETY PRACTICES WITH TOOLS.
Maintenance Service Interval Maintenance Procedure
Before Each Use or Daily Check Engine Oil Level.
Check Mower Blades.
Check Operator Presence Control System.
Check for Loose Hardware.
Clean Engine Cooling System.
Remove Debris From Engine.
Remove Debris Build-Up Hydrostatic Transmission & Cooler
After Each Use or Daily Clean Grass Build-Up from Deck Cutting Chamber.
After First 5 Hours Change Engine Oil.
After First 100 Hours Check Wheel Lug Nuts. (75 ft/lbs or 102 Nm)
Change Hydraulic Filter.
Every 10 Hrs Check Tire Pressure. (12 Psi / 83 kPa)
Check Battery Fluid
Sharpen Mower Blades
Every 25 Hours Service Air Cleaner. (Increase Frequency Under Severe
Conditions. See Engine Owner’s Manual for additional
information.)
Every 50 hours Check Hydraulic Oil Level.
Check Drive Belt Condition.
Check Engine RPM (3500-3600 rpm)
Every 100 hours Change Engine Oil & Filter. (Increase Frequency Under Severe
Conditions. See Engine Owner’s Manual for Additional
Information.)
Remove Engine Shrouds & Clean Cooling Fins.
Check Spark Plug
Check Wheel Lug Nuts. (75 ft/lbs or 102 Nm)
Every 400 Hours Change Hydrostatic Transmission Oil & Filter
Every 500 Hours
Or Annually Grease Front Caster Pivots
Replace Air Filter Element
Check Spark Plugs
Service Battery
Replace Safety decals when illegible. Write factory for free replacement.