6
2-2 Right PTO Mount Plate Assembly
Installation
2-3 Left Mount Plate Installation
2-4 Lower Mount Assembly
Installation
Fasten the right PTO mount plate assembly P#(A1230)
to the right panel guard using (2) 1/2”-13 x 1-1/2” HHCS
P#(K1233) and (2) 1/2”-13 nyloc nut P#(K1247). Use
existing hardware from the rear panel guard where
indicated. Refer to Figure 2-2.
Fasten the left mount plate P#(B0661) to the left panel
guard using (2) 1/2”-13 x 1-1/2” HHCS P#(K1233) and
(2) 1/2”-13 nyloc nut P#(K1247). Use existing hardware
where indicated. Refer to Figure 2-3.
It is recommended that someone assist you
during the lower mount assembly installation.
Lift the lower mount assembly P#(A0706) into position
as shown in Figure 2-4, and fasten to the left and right
mount plates, using (4) 3/8”-16 x 1-1/2” HHCS
P#(K1193) and (4) 3/8”-16 nyloc nut P#K1216. Refer to
Figure 2-4.
NOTE:
2-5 Exhaust Deflector Installation
.
NOTE:
All engine models that divert exhaust to the left,
will not require and exhaust diverter.
If your engine model diverts exhaust to the rear, fasten
the exhaust deflector P#(C0050) to the lower mount
assembly using (2) 1-4”-20 x ½” HHSTCS P#(K0353).
Refer to Figure 2-5a.
For engine models that divert exhaust to the right side,
attach the exhaust deflector P#(J0282) to the muffler
and secure with (1) exhaust clamp P#(X1064). See
Figure 2-5b.
Rotate the deflector down slightly to prevent the exhaust
from being diverted towards the collection bags.
.
Figure 2-2
(2) 1/2”-13 x 1-1/2” HHCS
(2) 1/2”-13 Nyloc Nut
Right PTO Mount
Plate Assembly
Use Existing
Hardware
Figure 2-3
(2) 1/2”-13 x 1-1/2” HHCS
(2) 1/2”-13 Nyloc Nut
Use Existing
Hardware
Left Mount
Plate
Lower Mount
Assembly
(4) 3/8”-16 x 1-1/2” HHCS
(4) 3/8”-16 Nyloc Nut
Figure 2-4
(2) 1/4”-20 x 1/2”
HHSTCS
Exhaust
Deflector
Figure 2-5a
Figure 2-5b
Exhaust
Diverter
Exhaust
Clamp