9
EN
G
LI
S
H
Assembly
Important: Unplug the lead before assembling the machine.
1. Remove the water tray, then undo the two screws holding the lower blade
cover and remove the blade cover.
2. Remove the blade nut and the outer flange washer from the spindle using
supplied spanners (leave the inner flange washer on the spindle).
3. Make sure that the blade is mounted so that it rotates in the direction indicated
by the arrow on the lower blade cover.
4. First place the blade onto the spindle and then the outer flange washer and
nut. Tighten the nut using the supplied spanners (N.B: The inner and outer
flange washers are different).
5. Screw the lower blade cover back into place and reattach the water tray.
6. Attach the upper blade guard bracket using two screws, and then attach the
upper blade guard to the bracket using the coach bolt and nut.
Test run the tile saw for a minute without cutting anything, check that blade rotates
in the same direction as the arrow on the upper blade guard and that it does not
wobble.