8
EN
G
LI
S
H
3. Charging
• The battery is supplied only partially charged and must therefore be charged for
between 5 and 7 hours prior to first use. The battery need not be fully discharged
before recharging. The battery will not be damaged by being charged regardless
of its charge level, and charging can be switched off at any time.
• Automatic shutoff. The battery is protected against excessive discharge; when
the battery voltage falls, the rotary hammer will be automatically switched off
via a safety circuit.*
• Temperature protection. The battery has been fitted with a temperature sensor,
which only allows charging when the battery temperature is between 0 and 45 °C.
• If only one of the LEDs on the battery indicator (5) illuminates for around five
seconds when the power switch (9) is pressed in halfway (or fully), the battery has
less than 30 % of its charge remaining and must be recharged.
• If the rotary hammer is not going to be used for a long period of time, the battery
must be fully charged before being put away for storage.
1.
Connect the charger to an electrical power socket and then connect the DC plug
(15) to the charging socket (14).
2. The battery indicator will indicate the progress of the charging. When all four
LEDs are illuminated, the charging is complete. The charging time will be around
5–7 hours for normal usage. It is normal for the handle of the rotary hammer to
become warm during charging.
3. Remove the charger from the electrical power socket and then remove
the DC plug. Protect the charger against water and humidity.
Important!
The rotary hammer cannot be used when the DC plug is connected.
*WARNING!
Release the power switch (9) immediately if the rotary hammer switches
off automatically. Failure to do this may result in damage to the battery.
Summary of Contents for PLCT0301
Page 2: ...2 ...
