18
EN
G
LI
SH
12. Attachments, assembly
Assembly of extension table
Rear extension
1. Loosen the four bolts on the back of the table frame, mount the extension table (200) from above;
make sure that the four grooves on the table’s edge come before for each bolt.
2. Mount the M6x16 carriage bolts (203) from the outside in the hole on the cross support.
3. Attach the locking wheel (204) on the bolt but do not tighten it yet.
4. Mount the long support (202) on the bolt and tighten the locking wheel.
5. Mount the M6x16 carriage bolts (203) from the inside, in the hole of the table (200) and the hole in the
support (202).
6. Screw on the locking wheel (204) on the bolt (203) and tighten.
ATTENTION!
It is important that the extension table is not higher than the main table, otherwise the piece
can get stuck or kick back.
Extension on the right-hand side
1. Loosen the four bolts on the right-hand side of the table frame, mount the extension table (200) from
above; make sure that the four grooves on the table’s edge come before for each bolt.
2. Mount the M6x16 carriage bolts (203) from the outside in the hole on the cross support.
3. Attach the locking wheel (204) on the bolt but do not tighten it yet.
4. Mount the long support (202) on the bolt and tighten the locking wheel.
5. Mount the M6x16 carriage bolts (203) from the inside, in the hole of the table (200) and the hole in the
support (202).
6. Screw on the locking wheel (204) on the bolt (203) and tighten.
7. Push two carriage bolts (206) in the notch on the extendable ruler (205), mount the M6 flat washer and
locking wheel.
8. Attach the extendable ruler (205) on the front of the table (200).
9. Adjust the extendable ruler so that it is parallel with the existing ruler. Tighten the locking wheels (204).
Summary of Contents for CSB315
Page 2: ......
