11
Fig 12.
Fig 13.
Fig 14.
High fence
Fig 15.
Low fence
EN
G
LI
SH
5.8 Mounting the Rip Fence
Parts (Fig 13)
Name
Number
Extension
1
Stop
1
Nuts
2
Tightening bolt M6 x 20
2
Knobs
2
Tightening bolt M6 x 20
2
1. In order to be able to use the circular saw for longitudal cutting the rip fence must be attached to the
stop and to the ruler at the front of the table.
2. Push the screw heads into the cutting ruler
3. When the two nuts have been loosened, the rip fence can be removed and changed to:
• High fence: For rough pieces. Fig 14.
• Low fence: For thin pieces. When the saw blade is bevelled. Fig 15.
5.7 Adjust Parallelism
• Loosen the six locking bolts holding tight the attachment brackets to the motor under the saw table,
one revolution.
• Turn the motor unit until it is parallel with/or at the right angle to the rulers. Fig 12.
Summary of Contents for CSB315
Page 2: ......
