NOTE: The charger will automatically shut off to prevent
overcharging. Leave the unit plugged in to make sure it is
charged for emergencies.
NOTE: Do not use while unit is recharging. Disconnect from
charger before use.
NOTE: Do not run for more than 10 minutes maximum at a
time. Allow it to cool down for 10 minutes before using
again.
The air compressor is rated for 180 PSI.
a. Remove the air compressor hose from the storage position.
Install adapters as necessary.
b. Attach the air compressor hose to the product or accessory to
be inflated.
c. Turn AIR COMPRESSOR Switch on and inflate the product.
d. When the product is inflated to the proper air pressure (using
the air compressor gauge), turn the AIR COMPRESSOR SWITCH off
and remove the hose.
e. Recharge the unit as soon as possible after using the air
compressor.
USING AIR COMPRESSOR
INFLATING OTHER INFLATABLES WITH
ADAPTERS (NOZZLES)
Inflation of other items requires use of one of the adapters
(nozzles).
1. Select the appropriate adapter nozzle.
2. Lift the thumb latch on the nozzle, insert the adapter (i.e.
needle) into the nozzle connector and close thumb latch.
3. Insert adapter (i.e. needle) into item to be inflated.
4. Turn on the Inflator Power Switch —inflate to desired pressure
or fullness.
NOTE: Small items such as volleyballs, footballs, etc. inflate very
rapidly. Do not over-inflate.
5. Remove adapter.
6. Switch the Inflator Power Switch off.
7. Allow unit to cool before storing away.
8. Store inflator hose and tire fitting in storage compartment.
● Red Indicator LED flashes and audible alarm sounds
Means the internal battery voltage is too low. The unit is never used
and needs to be charged immediately.
b. Press and release the button again after test to prevent draining
the battery needlessly.
a. Plug the AC Power Cord into the built-in adapter pin on the back
of the jump starter.
b. Plug the AC Power Cord into a 120V wall outlet.
c. Continue charging until the Green Battery Status Indicator LED
is kept on, and then reverse these steps when charging is finished.
CHARGING JUMP STARTER USING AC POWER CORD
VOLTAGE TESTING
Fluctuations in temperature can accelerate battery discharge.
Check the unit often
a. Press and release Test/USB/Light 3S button and check the
internal battery's voltage level from three Battery Status Indicator
LEDs.
● Green Indicator LED flashes and audible alarm sounds
Means the internal battery voltage is too high. Please check if the
unit is on charge wrongly.
● Green Indicator LED is on
Means the unit is charged and ready to be used.
● Yellow Indicator LED is on
Means the unit needs to be charged as soon as possible.
● Red Indicator LED is on
Means the unit is never used and needs to be charged
immediately.
08
09
