g. Start the engine for 3-5 seconds. If the engine does not start
within 10 seconds, stop cranking and wait at least 4 minutes
before attempting again. This permits the battery to cool down
and prevents damage and overheating.
h. Turn the unit off and disconnect the clamps, first negative and
then positive.
i.Recharge the unit after use.
NOTE: Your jump starter is used for only 12V vehicles. If it
connects to a 24V vehicle, the red LED will flash slowly with
constant alarm on. This could cause serious damage.
a. Connect the red (po) clamp to the positive input
terminal and the black (negative -) clamp to the negative input
terminal.
b. Make sure that clamps are connected correctly and firmly, and
then turn Power Switch to the ON position. The Connection Status
Indicator LED will turn Green, and the unit is now supplying
current to your device.
c. After using, turn the unit off, and then disconnect the clamps.
d. Recharge the unit after use.
USING AS A 12V POWER SOURCE
USING 12V CIGARETTE LIGHTER POWER
The 12V DC cigarette lighter outlet is protected by a 15 amp
circuit breaker, which resets automatically.
a. Turn Power Switch to the ON position;
b. Insert the 12V DC Cigarette Lighter plug from the device into
the Cigarette Lighter Outlet on the front panel, and the unit is now
supplying current to your device;
c. To use the unit with an external power inverter:
● Turn the external power inverter (not included) off;
● Plug the 12V DC Cigarette Lighter plug from the power inverter
into the Cigarette Lighter Outlet.
● Turn the power inverter on.
● Plug the device into the power inverter.
Using cigarette lighter plug extension cord:
Please insert one plug of the cigarette lighter plug extension cord
into the Cigarette Lighter Outlet on the front panel of jump starter,
and insert the other plug into your device's Cigarette Lighter
Outlet. Then the unit is now supplying current to your device.
JUMP STARTING A 12V VEHICLE
a. Turn device off at first.
b. Make sure Power Switch on the front of the unit is on the OFF
position at first.
c. Connect the red (po) clamp to positive pole on the
battery.
d. Connect the black (negative -) clamp to negative pole on the
battery
e. If internal battery voltage is <8V, red LED will flash with alarm
on. Please charge unit before use.
f. If connecting the clamps reversal, the red LED will flash quickly
with alarm on. DO NOT turn the unit on. This could cause serious
damage.
OPERATING INSTRUCTIONS
Use Your Jump Starter Safely
● If the unit is not fully charged it may shut down under heavy
load if it cannot deliver sufficient voltage.
● Failure to keep internal battery charged will lead to permanent
battery damage.
CAUTION
06
07
