![background image](http://html.mh-extra.com/html/costco/rc3218/rc3218_assembly-and-care-instructions_2671106009.webp)
9
NOTICE: Using a water spray bottle to extinguish flame
flare-ups can cause thermal shock to firebox porcelain
surfaces, and create “feathering” cracks in the porcelain.
Water can seep through the cracks and cause the
underlying metal to rust.
Ignitor Lighting the Grill
1. Read instructions before lighting your grill.
2. Open lid during lighting.
3. Open LP cylinder or natural gas valve.
4. Push control knob in and turn the knob to the left to “HI”
position. You will hear a clicking sound from all burners.
Keep pressing the knob until the burner is lit. For rotisserie
burner, after it is lit, still keep pressing the knob for another
10 seconds to be sure the burner stays lit.
5. If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes for gas to clear away, and repeat
the lighting procedure.
NOTE: If ignitor does not work, follow Match Lighting
instructions.
WARNING: The side burner lid must remain raised when the
side burner is in operation.
Main Burner Match Lighting
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place match into match holder (hanging from side of cart).
Light match, place into the firebox.
3. Push in and turn right knob to HIGH position. Be sure burner
lights and stays lit.
4. Light other burners by pushing knob in and turning to HI
position.
Side burner Match Lighting
1.
Open side burner lid. Turn on gas at LP cylinder.
2.
Place lit match near burner.
3.
Turn side burner knob to HI. Be sure burner lights and
stays lit.
Burner Flame Check
•Remove cooking grates and heat diffusers. Light burners,
rotate knobs from HIGH to LOW. You should see a smaller
flame in LOW position than seen on HIGH. Perform burner
flame check on sideburner, also. Always check flame prior to
each use.
Turn off controls and tank or gas supply when not
in use.
Please make sure the drip tray and drip cup are
properly installed before turning burners on.
Drip tray is hot when burner is on and after grilling.
Do not touch the drip tray when it is hot.
If ignition does not occur in 5 seconds, turn the
burner control off, wait 5 minutes, and repeat the
lighting procedure. If the burner does not ignite
with the valve open, gas will continue to flow out
of the burner and could accidently ignite with risk
of injury.