OPERATING INSTRUCTIONS
-
Continued
INTERNAL BATTERY CHARGE LEVEL Status:
To check the internal battery charge level status.
•
Press the Main Power ON/OFF Button
(1)
to ON position
•
The Battery Charge Status Indicator Bars
(3)
will illuminate as follow:
4 LED Bars
illuminated (100% Charge Capacity)
……
Internal battery is fully charged.
3 LED Bars
illuminated
(75% Charge Capacity)
……..
Available power for the power bank and worklight operation.
2 LED Bars
illuminated
(50% Charge Capacity)
…….
Charge the unit as soon as possible.
1 LED Bar
illuminated (25% Charge Capacity)
.....…..
Charge the unit immediately.
NOTE: The Battery Charge Status Indicator Bars (3) will automatically turn OFF in 5 seconds after the LED lights are
turned ON and 30 seconds after the USB Output Ports are activated.
POWER BANK
The USB ports provide 5.0V
-
2.1A DC (total output power).
1.
Make sure the device is powered OFF before inserting the power plug into the USB ports.
2.
Lift the USB Power Output Compartment Dust Cover
(B)
and swing it completely open to expose the USB Output Power
Ports
(10).
3.
Plug the USB connector into the USB Port
(10)
of the Worklight/Spotlight.
4.
The USB Port
(10)
will automatically turn ON with available power.
5.
Turn ON the device that is intended to be operated by the USB port.
6.
Charge or operate the intended device such as iPhones, iPads, Tablets, and any USB power rated 5V enabled devices
(not included).
7.
Turn OFF the device and disconnect the device USB plug from the USB Port
(10)
after charging your device.
8.
Periodically check the battery charge level status of the Worklight/Spotlight by pressing the ON/OFF Power Button
(1).
Make
sure the internal battery does NOT deplete below a 25% charge level. Recharge the internal battery as required.
Standard Camera Tripods (Not included):
The Worklight/Spotlight Base is designed with an interface
(13)
that
can be attached to most standard camera tripods currently available in the market.
Page 8 of 10
B
10
13
13
