12
----End
Direct Installation by the Main Body Base Cover
Step 1
Fetch the positioning labeling from the accessory package, remove the release paper
from the positioning labeling, and stick the labeling to the place where the camera is to
be installed.
In the ceiling mount installation mode, you can route cables from the top or from aside.
Select the routing method depending on the installation scenario.
If you use the top routing method (which has high requirements on installation), drill a
routing opening with a diameter of 30 mm in the gap of the positioning labeling.
If the ceiling or eaves do not allow the routing opening, use the aside routing method.
When you route cables from aside, align the gap of the positioning labeling with the
cable routing direction and use the Plug Wrench to unscrew a plug on the lower cover to
facilitate cable routing.
Step 2
Use a drill with a diameter of 5.5 mm to drill three round holes with a depth of 40 mm
in the places marked with "B" on the positioning labeling. Use a hammer to nail the
three white plastic buttons into the round holes. Ensure that the wall surface is level
and the plastic buttons align with the wall surface. See Figure 3-9.
Drilling round holes and nailing plastic buttons
Top routing
Aside routing
opening
Three white plastic
buttons
Step 3
Unscrew the three black screws on the main body black base cover and keep the lower
cover immobile.
Step 4
Route the multi-head composite cables of the camera.
