FRONT PANEL FEATURES
SYNC SECTION
With the toggle switch in the center position SYNC is disabled. Flipping the toggle switch to the left
syncs VCO1 to VCO2. Flipping the toggle switch to the right syncs VCO2 to VCO1. The little switches
on either side of the toggle switch let you choose between hard sync (sometimes referred to as ‘reset’)
in the up position and soft sync in the bottom position (sometimes referred to as ‘flip’).
SYNC INPUTS
You can patch any external VCO (preferably a square or pulse) into the sync inputs of VCO1 and VCO2
to override the internal normalization.
V/OCT inputs
By patching a CV signal into either V/OCT input it’s possible to control the pitch of VCO1 and VCO2
seperately (offsetted by the positions of the coarse and fine tune knobs and the octave switch).
The range of both VCO1 and VCO2 is 20Hz to 20kHz. The V/OCT inputs have a high impedance
meaning you can use passively multed CV signals without accuracy loss.
V/OCT LINK SWITCH
You can use one V/OCT signal for both VCO1 and VCO2 by flicking the link switch to the right position.
This normalizes the V/OCT input of VCO1 to the V/OCT input on VCO2. Keep in mind that the relative
pitches of VCO1 and VCO2 remain unchanged.
VORTEX / Complex Oscillator
6
sync section
v/oct link
VCO1 v/oct in
sync inputs
VCO2 v/oct in
