12
13
24.40
” /620 mm
34
.4
4”
-3
5.
23
” /
87
5-
89
5
m
m
24.20” / 6
15mm
COS-24BIWCS Model uses side anti-dew tube and Independent cooling system
Minimum space required for COS-24BIWCS Model
Install Limitations
Do not install your wine cooler in any location not properly insulated or heated
e.g. garage etc.
Select a suitable location for the wine cooler on a hard even surface away from
direct sunlight or heat source e.g. radiators, baseboard heaters, cooking
appliances etc. Any surface unevenness should be corrected with the leveling
legs located on the front and rear bottom corners of the wine cooler. Avoid
placing
unit where there may be electrical
interference..
Note:
To minimize the risk of
rusting, leakage and insulation
damage, avoid placing the unit in
a place where heavy moisture is
present. Under no circumstances
spill or directly apply water onto or
into the unit.
Proper Air Circulation
To assure your wine cooler works
at the maximum efficiency it was
designed for, you should install it in
a location where there is proper air
circulation and electrical
connections.
Allow enough space in the front of
the unit to open the door to 120°.
DEFROSTING/CONDENSATION/ HYGROMETRY/ VENTILATION
Your wine cellar is designed with “Auto-cycle” defrost system. During “Off-cycle”
the refrigerated surfaces of the wine cellar defrost automatically. Defrost water
from the wine cellar storage compartment drains automatically and part of it
goes into a drainage container, which is located at the back of the wine cellar
next to the compressor. The heat is transferred from the compressor and evap-
orates any condensation that has collected in the pan. Part of the remaining
water is collected within the wine cellar for humidity purposes.
This system enables the creation of the correct humidity level inside your wine
cellar required by the natural cork to maintain a long lasting seal.
Notes:
The water collected by condensation, is therefore recycled. Under ex-
tremely dry environmental conditions, you may have to add some water into the
water container provided with your wine cellar.
All units are equipped with a double glazed glass door that has a third internal
acrylic layer to minimize condensation on the glass door.
The wine cellar is not totally sealed; fresh air admission is permitted through the
drainpipe. Air is circulated through the cellar by means of a fan/fans and the
hollow shelves.
Notes:
During the refrigerating cycle, heat is given off and disperses through the
external surfaces of the wine cellar. Avoid touching the surfaces during those
cycles
COSMO COS-24BIWCS Model With Sliding Roller
