5
use. Do not let clothing or other
flammable materials contact with
areas near surface burners until they
have had sufficient time to cool down.
WARNING! NEVER use this appliance as
a space heater to heat or warm the
room. Doing so may result in carbon
monoxide poisoning.
INSTALLATION REQUIREMENTS
TOOLS & PARTS
Gather the required tools and parts before starting installation. Read and follow the instructions
provided with any tools listed here.
Tools Required
1/4 inch (6.35 mm) Nut Driver
Pliers
Flat-head Screwdriver
Parts Included
Foam strip roll
Clamping brackets (x2)
Parts Required
A UL-listed -OR- CSA-approved connector for 1/2 inch (1.3 cm) diameter conduit
UL-listed wire connectors
Check local codes. Check existing electrical supply. See the “Electrical Requirements” section.
It is highly recommended that all electrical connections be made by a licensed, qualified
electrical installer.
LOCATION REQUIREMENTS
IMPORTANT!:
Observe all governing codes and ordinances. When installing the cooktop,
use the minimum dimensions given.
To eliminate the risk of burns or fire by reaching over the heated surface units, cabinet
storage space located above the surface units should be avoided. If cabinet storage is
to be provided, the risk can be reduced by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
The cooktop must be a specified cooktop that is approved to be installed either alone or
over an under-counter built-in oven. Check the cooktop base for an approved installation
label. If you do not find this label, contact your dealer to confirm that your cooktop is
approved.
The cooktop must be installed on a level countertop.
The cooktop should be installed away from strong draft areas, such as windows, doors,
fans, or strong heating vents.
The cooktop should be located for convenient use in the kitchen.
Use the countertop opening dimensions that are given with these Installation
Instructions. Given dimensions are minimum clearances.
A grounded electrical supply is required. See “Electrical Requirements”,
Pages 10-11
.
IMPORTANT!:
To avoid damage, check with your builder or cabinet supplier to make sure
that the materials used will not discolor, delaminate or sustain other damage.
Tape Measure
Marker or Pencil
2 1/2 inch (6.4 cm) clamping screws (x2)
