10
Gebruiks- en montagehandleiding Cosiglobe / Operating and assembly instructions Cosiglobe / manuel de montage et mode démploi Cosiglobe
2 . Installation instructions according collection: Cosiglobe
The Cosiglobe is supplied complete with pressure regulator (30 mbar) and gas hose. You only need to purchase
a gasbottle. These can be purchased at your local gas supplier.
1. Installing the Cosiglobe
Get your Cosiglobe carefully from its packaging. Select the location for your Cosiglobe. The location must meet
the following conditions:
-
Make sure that the Cosiglobe is placed on a paved (preferably stone) surface. The surface should be
completely flat and clean
-
The Cosiglobe should be placed at least two meters away from flammable materials and liquids.
If the Cosiglobe is installed properly, you can place lava rocks and ceramic logs on
the top. Grab first the small lava stones and place them on the ground. Every Cosi
fires is deliverd with 1.5kg small lava stones and 1.5kg large lava rocks included.
Take the small lava stones without grit and place it gently on the model Repeat
the same with the big lava stones and make sure it is covered with lava rocks. Make
sure you keep the ignition unit free of lava stones
. After placing the lava rocks,get
the ceramic logs out of the packaging. The Cosiglobe is always included with four
ceramic logs. The ceramic logs insert a campfire in the fire ring back. Make sure
the fire ring is minimal covered by the logs. When the logs block the fire ring, there
will be a dangerous situaties. The blockade of the fire ring will affect the air flow
of the ring and the flames will be different. This results in dangerous situations!
If you want to reorder the lava stones or ceramic logs, this is possible at your
purchase address.
When you are going to use the Cosiglobe for the first time, make sure that the device is turned at the
highest setting for 15 minutes. In this way, the lava stones are heated through and this ensures that any
bumps or air bubbles will disappear from the lava rocks
When you want to move or cleanup the lava stones and ceramic logs, make always sure that they have
cooled down completely.
The lava rocks and logs can be scorching black in time. This has to do with soot formation which always occurs in
devices which show a yellow flame. This soot can be removed by blowing / vacuuming with a vacuum cleaner.
The carbon black may be also brushed off with a dry brush.
