4-14
Proper
Improper
PLACING WORKPIECE ONTO WORKBED
Step 1 –
Press the s
aw bow up
button and elevate the saw bow until it reaches to its highest point.
Step 2 – Turn the
vise open/clamp
switch to the left to open vise.
Step 3 – Carefully place the workpiece onto the work feed table.
POSITIONING WORKPIECE FOR CUTTING
Follow these steps to position your workpiece:
Step
Action
vise clamp material
1
Turn the
vise open/close
switch to the right until the workpiece
is securely clamped.
confirm cutoff point
2
Press the
saw bow down
button to lower the saw bow until it
descends to just about 10mm (0.4 inch) above the workpiece.
precision position
3
Adjust until the cutoff point on the workpiece aligns with the
blade line.
ADJUSTING BLADE SPEED
Step 1 – Set the flow control to “0” position.
Step 2 – Press the
saw blade start
button to start the blade.
Step 3 – Turn the
blade speed control knob
to adjust the blade speed. The blade speed should be
adjusted based on the size and the material of the workpiece.
Lock lever
Summary of Contents for SH-510LDMM
