Cosen SH-250R, Instruction Manual

Page: 45 / 96

4 ‐ 13
Quick adjusting movable vise position
To quickly adjust movable vise position, please follow below steps.
Step 1 ‐ Lift up the pawl and move the movable vise toward workpiece until it stands against the
workpiece.
Step 2 ‐ Turn the movable vise handwheel to clamp the workpiece securely.
INSTALLING MATERIAL STOP BRACKET
This device is easy to cut the same length repeatedly and saves adjusting time.
Step 1 ‐ Install the depth bar and tighten the set
screw. The depth bar is taken off from the
machine base during transit for safety reason.
Step 2 ‐ Lift the saw bow and clamp material
securely with vise.
Step 3 ‐ Lower the saw bow to allow about 1 mm
clearance between saw blade teeth edge and the
top of the material. Then measure your desired
cutoff length.
Step 4 ‐ Loosen the fastening bolt.
Step 5 ‐ Slide and position the stopper so that the
end of stopper faces the direction of the front
end of the material. Then tighten the stopper
handle to fix the stopper in the bracket.
Step 6 ‐ Move the stopper bracket toward the
workpiece so the stopper end just touches the
front of the material, then tighten the fastening
bolt.