Cosen C-320NC, Instruction Manual

Page: 69 / 166

4-33
Proper and improper stacking of workpieces
Proper Improper
Step 4 – Align the top clamp cylinders with the center of the workpiece and tighten the lock nuts.
Step 5 – Turn the top clamp handles so that the clearance between the top clamp jaw and the top of
the bundled workpiece is within 5 to 10 mm ( 0.2 ~ 0.4 inch).
Step 6 – Install the bundle-cutting fence to the work tray. The fence is designed to prevent cut pieces
from scattering across the work tray. Adjust the width of the fence to be slightly larger
than the width of the bundle.
Step 7 – Press Single/Bundle cutting mode button and switch to bundle cutting mode.
Step 8 – For subsequent cutting procedures, refer to the instructions under manual operation and
automatic operation.
Uninstalling top clamp
Follow these steps to uninstall top clamp for cutting single material:
Step 1
– Disconnect the top clamp hoses.
Step 2 – Loosen the lock nuts and remove the top clamp.
Step 3 – Remove the stud bolts.
TERMINATING A CUTTING OPERATION
STOP

To terminate a cutting operation, press either the saw bow up button or the emergency stop
button.

The saw blade will stop running when the saw bow up button is pressed.

Both the saw blade and hydraulic pump motors will stop running when the emergency stop
button is pressed.

The machine will stop automatically when an error occurs. The error message will be shown on
the screen.
Page 69 Instruction Manual for C-320NC (B090) 08/11/2018