9
4) Attach the Handlebar Support
a.
Put the cable end of resistance cable of Tension control (41) into the spring hook of Tension control wire
(38) as shown on drawing
A
of figure 4.
b.
Pull the resistance cable of Tension control (41) up and force it into the gap of metal bracket of Tension
control wire (38) as shown on drawing
B
of figure 4.
c.
Connect the resistance cable of Tension control (41) with the Tension control wire (38) completed as
shown on drawing
C
of figure 4.
d.
Insert the Computer wire (17&18) through into the bottom of Handlebar support (7) and pull it out from
the top hole of Handlebar support (7).
e.
Insert the Handlebar support (7) to the Main frame (4) and secure it with four sets of M8x16 Bolts (42),
Φ
8 spring washer (50) and
Φ
8 Arc washers (34). (See figure 4)
5) Attach the Handle Pulse Tube and Computer
a.
Insert the pulse wires (19) through into the hole of the
Handlebar support (7) and then pull them out from the top
hole of Handlebar support (7). Attach Handlebar (8) to
Handlebar post (7) with three sets
of M8x20 (60) ,
Φ
8 spring
washers (50) and
Φ
8 arc washers (34). (see figure 5)
b.
Connect the Computer wire (18) and the Pulse wires (19), and insert the surplus wire into the Handlebar
support (7). (See figure 5)
Summary of Contents for CEB-TRIM 250U
Page 1: ...Magnetic Upright Bike OWNER S MANUAL CEB TRIM 250U...
Page 7: ...6 4 Overview Drawing...
Page 8: ...7 5 Hardware Packing List...
Page 14: ...13 B23458 C 0801 1400...
