6
FIG.1
ASSEMBLY INSTRUCTION:
1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above
of this instruction sheet you will find an explosion drawing with all single parts (marked
with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
:
FIG.2
FI G.2:
As shown in the figure, the main frame assembly (1) is padded
with packing material (A), and the screw (17), (18) which is
pre-locked on the connecting pipe assembly of the left and
right front foot tubes and the upper screw (18) of the main
frame assembly (1) are put on the side and back for assembly.
The right front foot connecting pipe assembly (3) is inserted
into the square pipe corresponding to the main frame
assembly (1) and locked with three M8*20 internal hexagonal
screws (17) and eight elastic gaskets (18). The other side is
assembled in the same way.
Take the packing material (A) padded under the main frame
assembly (1). Cover the front cover (10) on the square pipe at
the front end of the main frame assembly (1). Lock it with two
4.2*19 cross groove disc head screws (18).
FIG.1:
Remove the pre-lock board (C) and two bolts (B) at the
front end of the main frame assembly (1) and throw them
away. Follow-up installation steps are not needed.
As shown in the figure, turn the upper column assembly (4)
in the direction of arrow until the upper column assembly
(4) is close to the main frame assembly (1). One person
holds the upper column assembly (4) and the other person
connects the signal line (A1-A2) after the connection is
completed. The terminal is inserted into a large sheet metal
hole on the main frame assembly (1) to avoid
overwhelming the signal line.
As shown in the figure, the sheet metal on the upper
column assembly (4) is clamped into the main frame
assembly (4) which is pre-locked.
