Cosatto HUGO COT, Instructions Manual

Page: 4 / 16

cot assembly
1 – attaching the fixed side
Attach the fixed side (
3
) to one of the cot ends (
1
) . Ensure that the drop side mechanism is on the
opposite side to the fixed side. Insert 2 of the short bolts (
A
) through the end of the cot side and into
the threads in the cot end. Loosely assembly - do not tighten.
Repeat with the other cot end
( 2 ) .
2 – fitting the mattress base
Carefully turn the cot on its side and place the mattress base (
4
) in position.
Choose the preferred mattress base height - 3 options.
Place the barrel nuts
(
C
) into the bottom of the mattress base. Use a flat end screwdriver to align the
barrel nuts holes with the screw holes. Fit the long bolts (
B
) into the holes in the cot ends and screw
into the barrel nuts. Loosely assemble - do not tighten.
3 – fitting the drop side 1
Fit the runner screws (
D
) to each end of the drop side.
There should be movement in the cot as the bolts have not been tightened yet.
Attach the drop side
(
5
) to the cot ends. Insert the head of the runner screws on the drop side into the
top of the slot in the cot ends.
4 – fitting the drop side 2
Allow the pins on the drop-side to rest against the cot ends.
Lift the drop-side ‘W’ until the pins are within the area ‘X’ in the channels. Press in the spring loaded
pins ‘Y’. Protect the surface of the cot by using a screwdriver or a similar flat object and gently push the
lower part of the drop-side inwards ‘Z’ until the pins spring out and locate in the channel.
To complete the construction process, tighten ALL bolts.
5 – lowering the drop side
1
Lift the drop side.
2
Push the bottom edge inwards.
3
Lower the drop side.
6 – raising the drop side
4
Fully lift the drop side.
5
Push the bottom edge outwards.
6
Lower, ensuring both bottom corners are engaged.
7 – drop side removal
Loosen all the screws holding the cot ends to the fixed side and the mattress base.
Adjust the position of the drop-side until the pins align with the channel near the centre of the track.
Pull the drop-side forward and then down. This will push the spring loaded pins in so that the
drop-side can be removed from the track.
Protect the surface of the cot by using a screwdriver or a similar flat object to keep the pin in place.