Cosatto CHA CHA, User Manual

Page: 6 / 41

14 - using the hood - 2
A pocket for a tablet computer is located in the front section of the hood.
To fit your tablet computer (not supplied) pull back the flap (a) and carefully slide the tablet into
position (b). Once in place fold the flap back to cover the open end of pocket.
NOTE:
Please ensure the open end of the pocket is covered at all time
even if pocket is not in use.
NOTE:
Your tablet computer must be no more than 250mm x 190mm
x 10mm in size and weigh no more than 700g.
Remove your tablet computer before folding back the hood or closing the pushchair.
WARNING: See the “safe use of electronic goods” section at the
beginning of the document regarding the safe use of tablet computers.
15 - fitting the bundle bag
Place the bundle bags straps over the pushchair handles (a) and secure by fastening the poppers
on each strap (b).
Maximum load 1.5kg of goods, evenly distributed.
16 - fitting the drinks holder
Push the drinks holder down on to its mounting bracket until it locks in place.
Lift the drinks holder off the bracket to remove.
WARNING:
To avoid risk of injury from burning, do not place hot
beverage on drinks holder.
17 - using the raincover
With the hood opened or in the extended position, place the split, shorter section of the
raincover over the hood so that it hangs at the rear of the pushchair (a).
At the front wrap the straps around the chassis and fasten the press studs (b).
At the back secure using the fabric fasteners at the rear (c).
18 - removing the seat for cleaning
Secure attachment of the seat cover is critical to the safety performance of your
pushchair.
Removing and re-fitting involves a series of fasteners as per instruction below – please follow this
information carefully.
Tips:
• Having the pushchair semi-folded will release tension in the seat cover and make the fabric
sections easier to remove
• When passing the buckle through the plastic slots, keep the curve of the buckle in line with the
curve of the tubing and ease through the slot. If this is tight, use a blunt edge e.g. a coin or
broad screwdriver blade to help.
If fitted, remove the bumper bar (See step 9).
Unzip the top of the backrest and remove the three panels from inside (a).
Unfasten the fabric fasteners at the rear of backrest holding the seat cover to backrest tubing (b).
Unclip the waist straps from the frame by unfastening, then feeding the edge of the webbing
through the opening of the metal clip (c).
Unclip the seat straps by folding the buckle flat and pushing it through the slot in the mounting
block (d). There are three buckles on each side of the pushchair. One at the top of the backrest
and two on the underside of the seat.
Unclip the seat support strap from under the seat by feeding the edge of the webbing through the
opening of the metal clip (e) and unwrapping the strap from the frame on each side (f).