CORVUS TERRAIN T21, User Manual

Page: 64 / 84

We reserve the right to modify the product and the design. 64
USER
MANUAL
brake wear brake fluid
If the thickness of any of the front or rear disc brake pads is less than 1.5
mm, completely change the set of affected pads.
Check that the thickness of the front and rear discs is at least 3.5
mm.
It is important to keep the area around the discs, pads and wheel
spindles clean. Do not allow mud or external elements to accumulate
over long periods of time. These elements can affect the performance,
effectiveness and life of the materials.
We recommend that you go to your CORVUS dealer to change the
brake pads. They will also check for any possible wear of the brake
discs.
Inspect the brake fluid and change it regularly.
You must also change it if is contaminated by water or dirt.
Recommended fluid: DOT-4 brake fluid.
Do not mix different types of brake fluid. The fluid used to fill or
renew your circuit must respond to the specified standard in the fluid
reservoir of each circuit. You should NEVER change the specification,
always respect the dot-4 specification. What is important is not that
the brake fluid should be the same brand, rather that it MUST HAVE
the same specification. NEVER use fluid from a container that is not
sealed (unopened) at source. NEVER use brake fluid that has already
been used.
The brake fluid level must be within the MIN/MAX range. If there is not
enough liquid, it should be added.
Do not spill brake fluid on paintwork.
Check that there is no
loss of liquid through
the gaskets. Check for
possible damage to the
brake sleeves.
It is recommended that
you replace the brake
fluid every 2 years.
1