4.
Connect factory 16-pin plug to installation harness 16-pin socket
(See
Fig. 3)
Fig. 3
16-pin socket
5.
Connect harness 16-pin plug (See
Fig. 1
) to XM module or 6-disc
changer harness. (See
Fig. 2
)
6.
Locate internal fuse panel under passenger side toe board and tap HTD
Seat/WPR RLY (heated seat/wiper relay) fuse location or alternate 12V
accessory sources circled in red.
Accessory supply ensures module
turns “ON” only when vehicle is in operation.
Turn ignition “ON” to verify module LED is flashing, otherwise
use
voltmeter or test light to verify supply.
C6 fuse panel in passenger footwell
Alternate 12V accessory fuse box options include:
1. EXL DML (Exhaust Module)
2. WPR/WSW (Windshield Wiper/Washer)
Do not connect module accessory wire to 12V battery (always on) circuit.
Warning:
Check noise from motors, sensors, modules etc. and if present, locate
alternate power supply or purchase a
Vehicles with XM subscription and/or 6-
disc changer, proceed to “Pairing”
on page 4.
Vehicles with expired XM (no plans to renew) or without 6-disc changer
”
For instances where XM has expired and will not be renewed or vehicle does not
have 6-disc changer; a 3.5mm AUX input jack is provided to which users may
connect and play portable audio devices. (Not applicable to XM subscriber or
with 6-disc CD changers)
7.
Connect supplied 3.5mm audio cable (See
Fig. 4
) to module
“AUX”
input
jack (See
Fig. 5
). Route other end to front of the dash or wherever Aux
device will reside (within 16 ft.)
