NUV
ANT
™
MCT Instructions for Use
3
ENGLISH
Step 2: Charge the zLink
•
Connect the zLink Charger connector to the zLink and plug it into a
standard electrical outlet
•
If the lights on the zLink do not turn on, push the round
Power
button
for at least 2 seconds
•
Allow the zLink to charge for at least 6 hours
Step 3: Prepare for PiiX Application
• Trim as much hair as possible
from the intended location
[for
men]
on the upper left chest, as
seen in the diagram (for example,
using an electric razor or hair trim-
mer). Trim an area slightly larger
than the PiiX
• Using the Prep Wipe provided,
clean the skin where the PiiX will
be applied and allow time to dry
(clean an area slightly larger than
the PiiX)
•
Do not use any creams or lotions
on your skin before application as
this will impact monitoring
IMPORTANT: Monitoring will be affected if hair is not trimmed or if
skin is not cleaned with the Prep Wipe. If this happens, you may be
required to use another PiiX.
•
Remove the PiiX from the foil
pouch by tearing at the notch.
If you see any lights on the
PiiX before application, contact
Corventis Customer Service at
1-877-247-PIIX (7449)
•
Grasp the top side of the PiiX as
seen in the diagram and turn it
over to view the underside
•
Carefully pull each tab from the
underside of the PiiX to expose
the adhesive area
IMPORTANT: Take care not to touch the gel areas and not to fold the
fabric on to itself while you handle the PiiX.
