© Copyright, Core Protection Systems Ltd, 2021
Page 17
Pictorial instructions:
Written instructions:
1.
Don your mask. For the full donning procedure, please see section 3.2.1.2.
2.
Place the palm of your hands over the outward-facing openings on the filters.
3.
Inhale and hold for ten seconds to check the seal against your face. If fitted appropriately, the
inhaled breath should cause the inner and outer mask seals to press against your face and
this should remain for the duration of the inhale/hold. Also move your head to test if the seal
holds.
4.
If leakage occurs, adjust your mask and perform the fit check again.
3.2.1.4 During Use
WARNING: If you experience any of the following whilst wearing the product, leave the hazardous area
immediately and seek assistance.
•
Breathing difficulty.
•
Dizziness or nausea.
•
You can smell or taste the contaminant.
•
You experience any other noticeable side effects.
•
Your equipment becomes damaged.
3.2.2 Maintenance
This section applies only to the mask itself and does not include the filters unless stated otherwise.
