Quick Installation Sheet | CMA-267-AEN | Page 1
Corning Optical Communications
This document describes the installation procedure for the Corning® optical network evolution (ONE™) headend unit (HEU)
and relevant modules.
1.
REQUIRED KITS
The following items are required for installing the ONE™ HEU. If any of the listed items are missing, contact your
Corning representative.
HEU Kit
Qty
Item
Headend Unit Chassis (with blank panels on RIM and
one PSM slots) – includes factory-installed FAM in chassis
rear
1
FAM – single unit hosting four fans
(factory installed in chassis rear)
1
RJ45/RJ45 Communication Cable L = 2 m-2.15 m
(P/N 705900003) – HCM management cable
1
RIMe Kit (1-12 according to order)
Qty
Item
Extended Radio Interface Module (service specific)
1
Table 1. Kits Required for HEU Installation
CMA-267-AEN
Headend Unit (HEU)
Quick Installation Sheet
GENERAL INFORMATION
1. The HEU chassis is supplied empty and only includes the factory-
assembled fan module (FAM). All other modules are ordered separately
and must be installed.
2. Each HEU includes 14 slots — two for RF expander modules (RIXs) and
12 for extended radio interface modules (RIMes).
