System Installation
Remote Cabinet Installation
MA2000 Installation and Configuration Guide
35
Mount the MA2000 MRC on the wall as follows:
ATTENTION: The following instructions apply to an installation on a
concrete wall. For any other type of wall, contact MobileAccess.
NOTE: For installations that include an MA850/MA860 system, refer to the MobileAccess850/860
Installation and Configuration Guide.
1.
For integrated power supply configurations only (for other configuration grounding is
optional), connect the cabinet GND according to section
4.3.2.
2.
Using the plate as a guide, drill four holes for concrete anchors. Insert four concrete
anchors (McMaster-Carr catalogue number 92403A200, or equivalent).
3.
Mount the Plate on the wall. Carefully and thoroughly fasten the anchors to the wall.
4.
Assemble the Bracket onto the rear of the Remote Cabinet using the supplied screws.
5.
Lift the MA2000 MRC and guide the rear ledge of the assembled bracket onto the plate
bracket.
6.
Using the four screws, secure the RC Bracket to the Plate on the wall.
NOTE:
Tighten the screws only as much as needed to secure the Bracket to the Plate. One should be
able to loosen the screws quickly if needed.