13) Glue the Service Depart-
ment Oil Tank parts (36, 37,
38, 39, 40) together and place
where desired.
41
42
43
43
43
35
18
19
43
36
37
40
39
38
38
39
6) Assemble the Roof Sign halves (47, 48) as shown. Place
the top of the Sign on a flat surface as the glue dries to ensure
the assembly is level.
7) Glue Light Conduits (45) into each recess on the backside of
parts 47 and 48, and 49. Make sure they are straight and level.
When dry, add Sign Lamps (46) to the tip of each Conduit as
shown.
8) Glue the Downspouts (43) into the holes at the bottom of the
Roof Gutters and Side Walls.
9) Add the Electric Box (42) and Electric Feed (41) where desired
on the Back Wall.
10) Place the Heating Oil Tank
(35) along any wall you chose.
The opening on the back faces
the structure.
11) Glue the Chimney together
(18, 19) and onto the Roof (23).
12) Glue the Roof Sign Assem-
bly and Font Wall Sign Assem-
bly from step 7 to the roof and
wall as shown.
DECALING
1. The decals printed backward are the only two that must be placed on the inside of Glass parts (#24) to appear correct.
Careful positioning will hide the edges of the decals behind the window frames.
2. The "Honk To Open" decal is individual letters. They fit the recessed squares cast into Door (13) or start with the panels
that are directly under the window and work down.
3. The "456" decal is the business address. This decal fits the space above the Entrance Door (17).
DECAL APPLICATION
1. Trim out the decal and place in a cup of warm water for 15 seconds. Remove and let stand for 1 minute, or until the decal
moves freely. Slide the decal onto the model surface and gently blot off any remaining water.
2. Lightly Brush Micro Sol® on top. This softens the decal and makes it confirm to irregular surfaces. DO NOT TOUCH the
decal while wet.
3. When thoroughly dry, check for trapped air bubbles. Prick them with the point of a pin or hobby knife and apply more Micro
Sol®.
47
48
45 x8
46 x8
49
45 x3
46 x3
