UC 700 Series Continus-Flow Icemaker Installation/Service Manual
Publication Number: 630460127
- 8 -
© 2000-2011, IMI Cornelius Inc.
I
NSTALLATION
!
WARNING:
It is responsibility of the installer to ensure that the water supply to the dispensing equipment is provided with
protection backflow by an air gap as defined in ANSI A112.1.2-1979; or an approved vacuum breaker or other such
method as proved effective by test and must comply with all federal, state and local codes.
Failure to comply could result in serious injury, death or damage to the equipment.
Water pipe connecting and fixtures directly connected to a potable water supply shall be sized, installed and
maintained to Federal, State and Local laws.
1.
Keep unit in the upright position, remove carton and pallet from the Icemaker and inspect for damage.
If any
damage is found, file a claim with carrier immediately
.
2.
Locate startup card either on outside of container or on plastic liner. Fill in proper information and send one
to factory, and other copy to distributor. Postage is prepaid.
3.
Install the Dispenser first, following installation instructions supplied with the Dispenser.
4.
Remove the two hole plugs from the side of the dispenser.
A. The plugs are pressed in and sealed with a silastic sealant. To remove pry the outside cap off and then press
the inside plug into the bin. Discard both plugs.
B. Install the ice maker alignment brackets
(Supplied with icemaker)
to the dispenser (See Figure 2).
5.
Install the Icemaker:
A. Install the icemaker alignment brackets
(Supplied with icemaker)
to the icemaker (See Figure 2).
B. Roll the Icemaker into the cabinet alongside the Dispenser.
C. Level and align the icemaker to the dispenser using the four level adjustment bolts located on the lower front of
the Icemaker.
D. Install the locking bolt on the lower front of the icemaker.
E. Connect drain, power and water.
6.
Install transport tube:
A. Insert the ice transport tube through the bin into the transport elbow on the Icemaker.
(Note: The ice-maker is
equipped with a safety switch located at the base of the elbow, this switch will prevent the icemaker from running if the
elbow is not properly installed)
.
B. Align the nylon lock screw on the elbow with the recess on the tube. Install lock screw.
7.
Connect bin thermostat:
A. Locate bin thermostat cable supplied with the icemaker (Black cable) and connect to electrical box on the
UC700 and the receptacle on the side of the dispenser.
Figure 2.
Side Bracket Installation
ATTACH TO BIN
ATTACH TO BIN
LEFT SIDE INSTALL
RIGHT SIDE INSTALL
Summary of Contents for UC 700 Series
Page 38: ......
