Enduro Ice/Beverage Dispenser Operator’s Manual
Publication Number: 620916502OPR
- 8 -
© 2002, IMI Cornelius Inc.
5.
Rinse the B-I-B disconnects in the sanitizing solution.
6.
Sanitizing fittings must be attached to each B-I-B disconnect. If these fittings are not available, the
fittings from empty B-I-B bags can be cut from the bags and used. These fittings open the discon-
nect so the sanitizing solution can be drawn through the disconnect.
7.
Place all the B-I-B disconnects into the pail of sanitizing solution. Operate all the valves until the
sanitizing solution is flowing from the valve. Allow sanitizer to remain in lines for fifteen (15) minutes.
8.
Remove the nozzle and syrup diffuser from each valve and clean them in a soap solution. Rinse
with clean water and reassemble the nozzle and syrup diffuser to the valve.
9.
Remove the sanitizing fittings from the B-I-B disconnects and connect the disconnects to the appro-
priate B-I-B container. Operate the valves until all sanitizer has been flushed from the system and
syrup is flowing freely.
WARNING: If repairs are to be made to the beverage system, remove quick disconnects from the
applicable product tank, then relieve the system pressure before proceeding. If repairs are to be
made to the C
O2
system, stop dispensing, shut off the C
O2
supply, then relieve the system pressure
before proceeding. If repairs are to be made to the ice dispensing system, make sure electrical
power is disconnected from the unit.
