UT
Handbook for Use and Maitenance – 50000 WB-80-87-95
Edition
01/11
Revisione
00
2
50000WB_e111_E.doc
IDENTIFICATION DATA
CRANE MODEL:
P
P
P
P
50000 WB
__
SERIAL N°:_____________________ (The serial number is engraved in the frame,
near the outriggers exit and on the crane
identification plate, placed on the column).
FITTED ON VEHICLE (brand):___________________(model)____________________
CHASSIS NUMBER:_____________________
LIMITS IN USE
The crane/vehicle assembly is subject to the following limitations:
When stability, on front, is not granted (in front of driver’s cab), the crane
working area shall be limited to the rear180°. The rotation towards the front is
prevented with mechanical means. The load charts for the crane/vehicle
assembly, apply only to the authorised working area.
When stability is not granted on the rear (Body side), the crane working area
shall be limited to the front 180°. The rotation towards the rear is prevented with
mechanical means. The load charts for the crane/vehicle assembly, apply only to
the authorised working area.
When full stability is not granted, the lifting capacities in that working area are
consequently limited. In the front working area
ONLY
the here joint loading
chart is valid.(*)
When stability is not granted on the front (in direction of the driver’s cab), the
lifting capacities, in that working area, shall be consequently limited. In the back
working area
ONLY
the here-joint loading chart is valid.(*)
When stability is not granted on the side (in forward motion sense of the
vehicle), the lifting capacities shall be consequently reduced. For this
crane/vehicle assembly
ONLY
the here-joint loading chart is valid.
Others (to be specified):
________________________________________________________________
________________________________________________________________
________________________________________________________________
(*) Valid only for cranes equipped with double load limiting device.
