Core Products ELT-2701, Instruction Manual

Page: 8 / 61

8
9
Remote Control
The on/off switch is on the top of the REMOTE. Its LCD Display lights up when the REMOTE is “ON”. If the
LCD display is blank or the REMOTE does not turn on, the REMOTE needs to be recharged.
The REMOTE is set to shut off after 45 minutes or you can manually turn off using the on/off switch.
Receivers Control
Push and hold the power button on each RECEIVER until you see the green light. Push again, and the
RECEIVER turns off. If the green light becomes red, the RECEIVER needs to be recharged.
Channel Control
There are 2 RECEIVERS labeled 1 and 2. RECEIVER 1 = Channel 1, RECEIVER 2 = Channel 2. Both channels
are controlled by the remote. The selected channel is shown in the LCD Display under “C”. Set the channel
prior to setting the Mode.
Intensity Control
Adjust the INTENSITY using the + and - buttons on the REMOTE. Repeatedly push the + button on the
REMOTE to increase the intensity of the channel shown in the LCD display. Repeatedly push the - button on
the REMOTE to decrease the intensity of the channel shown in the LCD display.