Page 22
The safety and integrity of this machine can only be maintained when the equipment is regularly examined for damage
and wear and repaired. It is the sole responsibility of the owner of this equipment to ensure that regular maintenance
is performed. Worn or damaged parts must be replaced immediately or the equipment removed from service until the
repair is made.
Some types of PM need to be performed more often than others. The frequency of PM depends a great deal on the use
and environment of the unit. Basic scheduling is shown below, but timeline and PM schedules should be adapted to the
environment and usage that the unit receives. Refer to the OpenHub Manual for further maintenance information on
the console.
Maintenance Schedule
Daily
Weekly
Monthly
Every 6
Months
Yearly
Cleaning
Wipe down and clean Bike and Frame
X
Clean Console
1
X
General Maintenance
Check Pedals for damage and movement
X
Inspect Pedal Bolts
and Crank
X
Inspect seat for wear
X
Inspect Pedals
2
X
Tighten Seat Hardware
X
Inspect and tighten pedal toe clips and shoe straps
X
Inspect leveling feet
X
Check console settings and keypad performance
X
Clean and seal frame
3
X
Lubricate horizontal and vertical seat sliders
4
X
Lubricate pop-pins
5
X
Inspect welds for any signs of cracking
X
1
Wipe console with a soft, non-abrasive cloth to remove all sweat after each use. Use a soft, non-abrasive cloth and mild spray cleanser to clean the console. Never
use abrasive cleaning liquids, cleaning liquids with an oil base, ammonia, or alcohol.
2
Excessive side-to-side movement or bearing resistance indicates the pedals need to be replaced.
3
Use water with a non-abrasive soap, car wash soap, or bike cleaner soap to clean. Wipe with water and dry. Seal with wax or bike polish.
4
Dry film lubricant with PTFE or wet film lubricant with PTFE may be used. These products can be purchased online via bike companies, at bike shops, and at some
hardware stores. Apply a layer using a cloth to clean up excess.
5 “