3
Connecting the KP7
The KP7 is powered by the output of a PoE Ethernet switch or by a PoE injector.
The KP7 cannot be directly powered by a power supply. If you have terminated the CAT-5 wiring
be sure to continuity test the wire before connecting the KP7. Insert the RJ-45 connector into
the receptacle on the rear of the KP 7 and listen for the tab to click.
Give the wire a light tug to verify the connector is secure.
4
MAC ID
Changing buttons and changing color
The KP7 may accommodate changes to the buttons or to the overall color.
The steps for both are very similar.
Button changes – White pre-engraved buttons are included for some installations.
A total of 16 buttons are included with the unit.
Color Changes -
Light Almond
(KP7BK-LA) and
Black
(KP7BK-B)
color change kits are available (sold separately).
Custom buttons in all three colors are available. See your Rep or Distributor for details.
To change buttons or colors:
Remove the two small Phillips head screws holding the bezel in place and remove the bezel.
Replace buttons and bezel as necessary based on your installation programmed requirements.
Re-install the two small Phillips head screws.
Bezel
LAN/PoE Input
Output of a PoE Ethernet switch
or by a PoE injector
Favorite 1
Favorite 2
Favorite 3
Favorite 4
Off
V
V
F-1-A
Favorite 1
Favorite 2
Favorite 3
Off
Favorite 4
V
V
standard network switch
PoE Injector
