0 7
SECTION 03
CAUTIONS
DO’S
• Always install the appliance in accordance with this guide. If in doubt obtain
expert advice.
• Always make sure the electrical socket is accessible and located adjacent
to, but not above the wine cooler.
• Always disconnect the wine cooler from the electrical supply before carrying
out cleaning or maintenance.
• Always keep the specified amount of clearance around the appliance,
especially at the rear of the product, free from obstructions. Never obstruct
the air vents
• Before you dispose of an old wine cooler, take off the door and leave shelves in
place so that children cannot easily climb inside.
• Wait at least 2 hours before storing goods in the appliance once it has been
switched on.
DON’TS
• Never use aerosols or steam cleaners to clean the wine cooler.
• Never route the mains supply cord under carpet etc.
• Do not allow children to play with the wine cooler.
• Never sit or stand on the product.
• Never lean or put weight on the product.
• Do not use outdoors.
• Do not site the wine cooler on deep pile carpets or rugs.
• Never cut off the plug and hard wire into a fixed fused spur
• Do not touch the cooled surfaces while the appliance is operating; especially
not with wet hands, because skin can stick to cold surfaces.
• Do not place any electrical items inside the appliance
• Keep the appliance away from direct sun light, areas of high humidity and
areas of high temperature.
INSTALLATION
Positioning
Do not position this product in a location where it may be subject to extreme
temperatures, where it could be exposed to direct sunlight, or next to a heat source.
The unit should be located in a cool, dry place.
Allow sufficient clearance around the Wine Cooler and ensure it is positioned on a
stable and level surface. The wine cooler has 4 feet, adjustable up to 2cm. If the wine
cooler is on an uneven surface, adjust the height of the appropriate feet to ensure the
wine cooler is level and stable.
Connection to the mains supply should be made via a suitable socket which is easily
accessbile.
Allow a 10 minute minimum interval between transit and connecting the wine cooler to
a power source.
A
B
B
Shelf installation
To install the wine cabinet shelves, slide the shelf on to the guides on the sides of
the cabinet. To remove the shelves for cleaning and maintenance etc. pull the
shelf towards you to remove it from the guides.
Always maintain sufficient clearance for
ventilation around the wine cooler:-
It is vital that an 80mm gap is left between the
wine cooler’s rear and any surfaces (A)
Allow a minimum of 50mm between the wine
cooler’s sides and any surfaces (B)
The air inlets and outlets must not be covererd
or blocked at any time.
