ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
ASSA ABLOY
19
7.7) M35 Power/Remote Unlocking with M861 Propped Door, Forced Door
1.
®
ElectroLynx System Wiring Instructions (refer to Fig. 1 and Fig. 4)
a.
Look for the mating part on ASSA ABLOY doors and frames. Then plug in all connectors as shown
in Fig. 4 during product installation.
b.
Hard wire forced/propped, hard power and/or remote unlock (REX) as shown.
2.
®
Non-ElectroLynx System Wiring Instructions (refer to Fig. 1 and Fig. 4)
a.
®
Cut the 8-pin connector off the Power/Remote Unlock harness and hard wire to non-ElectroLynx
door harness. Remote power requires three conductors and remote unlock requires two conductors.
b.
Hard wire door harness to power transfer device.
c.
Hard wire forced/propped, hard power and/or remote unlock (REX), as shown.
Installation:
Black, 1
Red, 2
White, 3
Green, 4
Orange, 5
Blue, 6
Brown, 7
Yellow, 8
Fig. 4
Power/Remote Unlocking
Forced Door, Propped Door
®
ElectroLynx Wiring System
QC12 Electric Hinge
with 8 and 4-pin connectors,
12 wires and pigtail harness
®
ElectroLynx Door Harness
with 8 & 4-pin connectors.
Harness location is
dependent on door type.
Red, 1
Black, 2
White, 3
Green, 4
DPS Switch
*Wire for switch
contact closure
when door is opened.
Typical locations
shown in Fig. 1
C
*NC
REX Input
Connect to
Device
1
2
3
4
5
6
7
8
Red
Black
White
Orange
Blue
Brown
Y
ellow
Green
(-)
REX
REX
Data Out
Data In
RTS
(EGND)
+9
M35
Power/Remote
Unlocking
Harness
4
Tan
3
Pink
6 AA batteries MUST be removed from
controller if 784 Power supply is used.
Door
Outside
Escutcheon
Inside
Escutcheon
Ground Tab
Remote Power and
REX Connector TB2
Motor
Connector
TB1
M861 Forced
Door,
Propped Door
Harness
4-pin
connector
3 2 1
Controller
NOTE:
M861 Harnesses are
Illustrated on page 14
Specific connections
are defined on page 15.
END OF INSTALLATION INSTRUCTIONS
784
9VDC
Power Supply
120 VAC L/N/G
EGND
+9 VDC
-9 VDC
C
NO
Normally Open
momentary switch
(Remote unlock
- REX option)
7) ML20800 TCAC2 Hardwiring Instructions
