CORBERO CCIG2902D, Instruction Manual

Page: 72 / 81

18
E1
Open circuit failure of
thermocouple
Please contact after sales service.
Error Code for Induction hob
Problem Possible causes What to do
E1 Signal lost (PCB failure) Please contact after sales service.
E2/E3
Abnormal high/Low input
voltage Stop cooking and wait until input voltage back to
normal. If not please contact service center.
E4/E5/E6 Thermistor failure. Please contact service center to repair.
E7
Abnormal high
temperature (dry
burning) Cut off power, wait for 30min and switch on.
If still not working, please contact service.
E8/E9
Failure of IGBT sensor Please contact service center to repair.
E0 IGBT Overheat Check if the fan is still working. If not please
contact service center to repair.
EE Display PCB failaure. Please contact service center.
The above are the judgment and inspection of common failures.
ATTENTION ! To avoid danger, please do not disassemble the unit by yourself!
9.
Installation
9.1
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5cm space shall be preserved
around the hole. Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant and insulated work surface material (Wood and similar fibrous or
hygroscopic material shall not be used as work surface material unless impregnated) to
avoid the electrical shock and larger deformation caused by the heat radiation from the
hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces
of
the worktop should be at least 3mm.
L(mm) W(mm) H(mm) D(mm) A(mm) B(mm) X(mm)
CCVG2902D 290 520 50 46 270 490 50 min.
CCVG8322 590 520 50 46 560 490 50 min.
CCVG8422 590 520 50 46 560 490 50 min.
CCIG2902D 290 520 62 58 270 490 50 min.
CCIG9322 590 520 62 58 560 490 50 min.
CCIG9333 590 520 62 58 560 490 50 min.
CCIG9422 590 520 62 58 560 490 50 min.