8
Select the vertical seal with the 12mm flipper (PN40095) and trim
to 1717mm. Fit trimmed seal to the fixed panel, the
seal must sit tight
against glass clamps (top and bottom).
Important:
Seal 'flipper' must be on inside of the enclosure.
Note:
Wetting the glass with water will help fit the seal.
Inside
Inside
9mm
12mm
PN40095
Trim to
1717mm
9
Fit the door handles to the door ensuring the
plastic washers are fitted each side of the glass.
PN60511
5
7
a:
Place door in position on the tray, fix wall channels to walls using 32mm screws and screw caps.
b:
Check door is centrally positioned, perfectly vertical and square in the frame.
Drill inside of wall channels using 3mm drill bit in the two lower positions shown. Fix using 10mm screws and screw caps.
c:
Check door is centrally positioned, perfectly vertical and square in the frame.
Drill the next four holes in the positions shown inside of the wall channels using 3mm drill bit. Fix using 10mm screws and screw caps.
a
10mm
ø 3
mm
10mm
ø 3
mm
Inside
b
Inside
c
Door
From
inside
32mm
