TROUBLE SHOOTING
UV-C Lamp
is not working
Water leak
between the
main body and
hose lock nuts
The plug is not connected
to the power supply
Connect the plug to the
power supply
The hose lock nut is
loose
Tighten the hose barb or the
hose lock nut
The O-ring is not in
place
Install the O-ring
UV lamp base is loose
The lamp has expired
Replace the UV-C lamp
Push the UV-C lamp onto the
socket until a "click"is heard
UV LAMP
SOCKET
UV-C LAMP REPLACEMENT
The UV-C lamp has a useful life of about 8,000 hours.
To ensure effective performance, replace the UV-C lamp
before it expires.
How to replace the UV-C lamp
Disconnect the sterilizer from the power supply. (It is also necessary to disconnect the
power to the water pump).
Remove the threaded cap to
uncover the lamp socket.
Unplug the UV-C lamp out of the main body.
Pull the UV-C lamp out of the socket
(Be careful not to touch the lamp as it
may be hot).
Make sure that the pins of the lamp plugs
into the socket indicated with a "click".
Reverse steps 5-1 to reassemble the Turbo-Twist.
Please read the instructions in their entirety before
attempting to use this unit.
Never look directly at the unshielded
lamp as the ultraviolet radiation
emitted from the lamp can be harmful.
Do not pull cord to disconnect power.
Cut off the power and stop using if
the unit was submersed or dampened
by water
Cut off the power immediately if water
enters into the Quartz Housing.
Cut off the power if there is a burning
or smoking smell.
Never connect the sterilizer to the
power outlet while hands are wet.
Always leave a drip-loop in the power
cord to prevent water from running
down the length of the
cord and reaching
the power
outlet.
Though the Turbo-Twist is water
resistant, it should never be
intentionally submersed in water.
Always install the sterilizer in a location
where there is little likelihood of flooding
or water dripping directly onto the unit.
The water temperature flowing
through the unit should be below
105
o
F (40
o
C).
Make sure that appropriately sized
hose lock nuts are positioned on
hose barbs before attempting to
connect tubing.
Always disconnect the unit from the
power supply before shutting down
the flow of water to prevent the unit
from overheating.
Only a 120V (60 Hz) electrical
source should be used with the
Turbo-Twist.
WARNING
UV LAMP
SOCKET
