PowerPro II
47
CopyPro PowerPro II
While the value of the Auto Setting is not shown, typically for black ribbon it is 15
and for a color ribbon is 15.
•
For manually setting the Strobe Setting, use the Slider Bar to adjust strobe over a
range of values. In general, the higher strobe setting, results in darker labeling.
•
If label is too dark reduce strobe setting by 5 units and re-print, repeat this process
until proper print out is obtained
•
If label is too light increase strobe setting by 5 units and re-print, repeat this
process until proper print out occurs. Please note: if strobe setting is above the 15
unit range or higher and print is light, first try a lower strobe setting in the 15 unit
range and increase the strobe. In some cases a very high strobe setting will result
in a uneven light a print, and increasing the strobe setting further may cause the
ribbon to melt or tear when printing. If this occurs, reduce the strobe setting, and
check printout, if print out is fuzzy cleaning the print head may be required (see
Maintenance Section for print head cleaning information).