PowerPro II
25
CopyPro PowerPro II
Printer Ribbon Installation Chart – Part 1
Remove Cover
•
Remove the top cover by carefully lifting and
pulling forward. Remove used ribbon from
printer
Note: Ribbon rollers are held in place by locking
clips secured by thumbscrews. Loosen but do not
remove thumbscrews to adjust roller clips.
Load Ribbon Rollers
•
Insert the Supply Ribbon core on to the silver
Supply spindle (shown)
•
Insert the take up core on to the grey take up
spindle
Note: Ribbon Roller has a metal pin that fits into a
notch ribbon cores
Putting Rollers in printer
•
Supply Roller is placed into area at the front of
the printer.
Note Supply Roller has metal shaft with square end
that fits into square hole in printer frame
•
Take up core is placed in area at in the middle
of the printer.
Note Take up core Roller has metal shaft with round
end that fits into round hole in printer frame
Open printer chassis
•
Open printer chassis
•
Pull out chassis knob, to release chassis lock
Note: Lift chassis up using handle on side of the
chassis. Printer chassis will stay in vertical position
when it is fully opened
Locking clips
Pin
Chassis Lock Knob
